Great-planes MiGLET Ducted Fan ARF - GPMA1866 Manuel d'utilisateur

WARRANTYGreat Planes®Model Manufacturing Co. guarantees this kit to be free from defects in both material and workmanship at the date of purchase.This

❏ 6. Cut a slit at the marks on the elevons 1/4" [6.4 mm] long5/16" [8 mm] from the leading edge of the elevons. Enlarge thelowest hole in t

❏ 2. Measure 6" [152 mm] from the front of the duct channeltop and stick the “hook” side of the hook and loop materialto the channel top.❏ 3. Ins

❏ 5. Drill a 1/16" [1.6 mm] hole through the fuselage at anangle for the receiver antenna as shown. When drilling thehole, be sure your drill is

At this stage the model should be in ready-to-fly condition withall of the systems in place, including the receiver and ESC.❏ 1. Use a felt-tip pen or

first. Look for loose servo connections or broken wires,corroded wires on old servo connectors, poor solder joints inyour battery pack or a defective

Turn on the transmitter and plug the battery into the speedcontrol. Turn on the receiver by following the instructions thatcame with your ESC. Secure

BUILDING NOTESKit Purchased Date: _______________________Where Purchased:_________________________Date Construction Started: __________________Date Co

2INTRODUCTION ...2AMA...

2. You must assemble the model according to theinstructions. Do not alter or modify the model, as doing somay result in an unsafe or unflyable model.

If you have purchased the version of the MiGLET ARF thatincludes the HyperFlow™EDF unit, a 370 BB brushed motoris also included so you will not need t

Mail parts orders and payments by personal check to:Hobby Services3002 N. Apollo Drive, Suite 1Champaign, IL 61822Be certain to specify the order numb

6Before starting to build, take an inventory of this kit to make sure it is complete, and inspect the parts to make sure theyare of acceptable quality

❏ 1. Glue the wing tips to the wing using foam-safe CA glueor epoxy. Be careful when gluing the tips as any excess will bedifficult to clean up from t

❏ 5. Drill a 3/8" [9.5 mm] hole at the mark you made. A drillbit or hobby knife can be used. However, we suggestfollowing the “Expert Tip”below.❏

❏ 2. Drill a 3/8" [9.5 mm] hole in the forward inside corner ofeach servo bay for the servo leads to pass through. The holesshould be approximate